Automotive Accessories

Builder Flips Jeep Differential Upside Down for a Cut-Price Portal Axle

Zeph Gage's rear-only portal conversion for an XJ Jeep pairs a Ford 9-inch housing and Humvee geared hubs with an inverted differential to reach roughly one-fifth the cost of a typical set.

Astrid BerglundNovember 17, 20265 min read2 views
Concept illustration of an off-road vehicle's rear axle on a workshop stand, with the differential housing mounted upside down and a geared portal hub fitted at the wheel.

A Jeep builder has worked out how to add a portal axle to a four-wheeler for a fraction of the usual price, combining a flipped differential with surplus military parts. Zeph Gage's conversion puts a single portal axle under the rear of an XJ-generation Jeep, built around a Ford 9-inch axle housing, geared hubs taken from a Humvee and a set of HMMWV portal adapters from Jesse Haines Fabrication.

What a portal axle buys

Portal axles are prized by hardcore off-roaders because they raise a vehicle and improve its ability to clear obstacles, whether the terrain is Moab slickrock or volcanic ground in Iceland. In a conventional driveline, shafts and other components hang below the transmission and transfer case. A portal arrangement instead places a stack of gears behind each driven wheel, so the axle shafts can sit high and very little hardware hangs below the frame line. Tall tires add further clearance on top of that.

The catch is cost. A typical set of portal axles from suppliers such as 74Weld runs about $20,000. Gage's rear-only arrangement comes in at roughly a fifth of that figure.

Turning the diff upside down

Two-gear portals of the Humvee type reverse the rotation of the input shaft. To make that work with the Ford 9-inch, Gage flipped the differential upside down so the driveline spins in the correct direction, then bolted a Yukon Gear and Axle third member to it. The result is effectively a budget high-pinion unit assembled from low-pinion parts that have simply been turned on their head.

The arrangement brings benefits beyond the roughly six inches of extra clearance. It keeps full shock travel, something that is difficult to achieve with portal axles, and it reduces load on the differential itself. Gage expects the assembly to be effectively bulletproof as a result.

Why only the rear

Fitting a portal at the back without matching it at the front is a familiar trick in the radio-controlled rock-crawler scene. Keeping the solid axle up front spares Gage the packaging constraints that usually appear when portal axles are fitted to a vehicle that never left the factory with them. It also means shock travel does not have to be limited to make room, and the ride height does not end up absurdly tall.

Custom hardware

The conversion is not an off-the-shelf kit. Gage fabricated much of it himself, from homemade brackets and custom-tapped plates to a two-piece brake rotor paired with a Ford Fusion caliper. He chose the Fusion hardware partly because it incorporates an electric parking-brake solenoid, and partly for clearance reasons.

The finished XJ can drive over a five-gallon bucket and still have several inches of clearance to spare, which means the rear end is less likely to hang up on obstacles the front can steer around. Gage covers further detail, including how he matched gearing at both ends, in a video from Outdoor Auto.