Custom Manufacturing

DIAL pairs slot-die ink extrusion with light projection for thick functional inks

Northwestern's hybrid method levels particle-filled inks into sheets as thin as 25 microns before a 405-nanometer projector crosslinks selected regions.

Maren ToussaintNovember 9, 20265 min read3 views
Concept illustration of a hybrid printhead leveling a thin sheet of particle-filled ink before a blue-violet projector patterns selected regions.

Researchers at Northwestern University have developed a hybrid 3D printing method called direct ink additive lithography (DIAL), designed to print thick, particle-filled extrusion inks at speeds and resolutions closer to those of light-based processes. The work, led by Pranav Kaarthik, was published in Science Advances.

The method targets a long-standing trade-off. Digital light processing depends on low-viscosity, weakly scattering resins, while direct ink writing can handle functional yield-stress inks but is slowed by filament deposition and limited by nozzle diameter.

Ryan Truby, June and Donald Brewer Junior Professor of Materials Science and Engineering at Northwestern, said manufacturers have had to choose between the materials they need and the printing speed, resolution and scale they want, and that DIAL lays a foundation for removing that compromise.

How the process works

For each layer, a slot die extrudes ink onto the substrate and a doctor blade scrapes it into a sheet as thin as 25 microns. A 405-nanometer projector then travels over the sheet and crosslinks selected regions, with uncured ink left in place to act as support.

Because light only has to pass through a thin sheet, opaque and heavily filled inks remain printable. The projector's 50-micron pixel pitch sets the planar resolution.

Demonstrated parts and print times

Using a model ink of polyurethane-based resin thickened with fumed silica, the team printed a 60 mm by 40 mm log pile structure in 30 minutes, against 124 minutes with direct ink writing, along with fins about 150 microns thick. Rastered projection over overlaid ink sheets produced a multimaterial lattice four times the projector's illumination area.

Other demonstrations included:

  • Interlocking chain mail with struts about 250 microns thick.
  • Fifteen gyroid structural electrolyte lattices printed from an ionogel ink in a single 15-minute run.
  • Hydrogel cell culture inserts containing 0.5-mm-deep inverted pyramids.

Limits and next steps

The authors described their print times as conservative, noting that tool changes had not been tuned for speed. They also said the absence of the suction and peel forces found in vat-based printing should make it easier to expand build area and volume.

Truby said rebuilding American manufacturing will depend on new ways to make advanced materials, and that because DIAL can print many complex, functional parts at once, the team sees a path toward scaling the method from the lab to larger-volume manufacturing of architected materials for robotics, aerospace, healthcare and other applications.

Kaarthik and Truby are listed as coinventors on a U.S. provisional patent application. Funding came from the National Science Foundation, the Air Force Office of Scientific Research and Northwestern's McCormick School of Engineering.