Electrical Equipment & Supplies

FastConvert Converter Cuts Fire System Upgrade Cost at Stoke-on-Trent Primary School

C-TEC's conventional-to-addressable converter let a school reuse existing wiring instead of recabling or replacing its fire system.

Ingrid HalvorsenNovember 5, 20265 min read3 views
A school corridor ceiling with combined fire detector and sounder devices connected to a control panel by a single loop of reused wiring, shown in cutaway.

A conventional-to-addressable zone converter from C-TEC, FastConvert, has been used to upgrade the fire detection and alarm system at North Road Academy, an Islamic primary school in Stoke-on-Trent, avoiding the cost and disruption of a full replacement.

The school had initially considered a complete replacement of its fire system. Following a site survey, specialist electrical company W R Fire & Security identified the potential to enhance the existing conventional system by converting it to an addressable system using FastConvert.

Three alternatives assessed

Before opting for FastConvert, three possible upgrade routes were considered. A new conventional panel would have allowed the zones to be separated out and additional zones created, but it would have required extra cabling and left the school with a conventional system limited to reporting zonal fire and fault information.

  • Full re-cable: ruled out on budget grounds, as it would have added an estimated £10,000 in materials and additional labour, along with greater disruption and a longer installation timescale.
  • Converting the remaining six zones into loops: would have added around a week to the installation for two engineers, plus additional cabling, materials and disruption, at an estimated extra cost of £3,000–£4,000.

FastConvert was described as the only option that avoided all three drawbacks at once: it reused the existing wiring, delivered a genuine loop-based addressable system rather than a conventional one, and did so without the extra cost, labour or disruption.

What was installed

By using the old system's wiring, FastConvert upgraded the legacy conventional system into an open-protocol CAST addressable system. According to C-TEC, the system is capable of lockdown alert functionality and internet connectivity, and can accommodate the company's CAST-PRO false alarm resistant combined fire detection and alarm devices, which C-TEC describes as award-winning. To achieve this, two radials were combined into a single loop, with a dedicated two-loop panel installed for FastConvert.

Contractor's view

Wayne Riley, managing director of W R Fire & Security, said the company was very impressed with FastConvert and considered it extremely innovative in what it can do. Against a full re-wire, which would have added around £10,000 to the job, or converting the remaining zones into loops, which would have cost an extra £3,000–£4,000 plus a week's extra labour for two engineers, he said FastConvert was the clear winner. He added that it massively reduced installation time, site disruption and labour costs, and saved approximately £3,500 on the project.

Riley also said the company liked the new CAST-PRO devices and felt they were superior to other manufacturers' products because the sounder/VADs and multi-sensors are built into the heads, so separate sounder bases are not needed.