Industrial Machinery

KraussMaffei Extrusion Introduces Single-Stage PVC InlineMixing Process for Roofing Membranes

The continuous PVC InlineMixing route doses solids and liquids straight into a twin-screw extruder, removing the separate hot-cold mixing stage.

Dario MontelliNovember 17, 20265 min read6 views
Cutaway illustration of a continuous twin-screw extrusion line feeding a calender roll stack that forms a PVC roofing membrane, with gravimetric feeders mounted above the extruder throat.

KraussMaffei Extrusion has developed a single-stage extrusion process for manufacturing PVC roofing membranes, replacing the conventional two-stage route built around a separate heating-cooling mixer. The company describes the PVC InlineMixing process as a continuous alternative that reduces energy costs, shortens production time and supports a rapid return on investment for the system, while also cutting staffing requirements compared with a dry-blend premixing setup.

From batch dryblend to continuous dosing

In the established two-stage method, PVC powder, plasticizers, additives and fillers are processed batchwise in a hot-cold mixer combination to produce a dryblend. After cooling and intermediate storage, the mixture is plasticized in a twin-screw extruder and formed into membrane. Under PVC InlineMixing, all solid and liquid components are instead fed directly into the extruder by gravimetric dosing systems in the required proportions, so the separate mixing and storage step is no longer needed.

Claimed savings and production flexibility

According to KraussMaffei, the single-stage arrangement eliminates investment in a separate heating-cooling-mixing combination and heats the material only once. Energy consumption, and therefore energy cost, falls by up to 75 percent — a figure the company qualifies as dependent on the formulation, the system parameters and the plant location. Dropping the separate mixing process also reduces the space required for the whole system and lowers labor costs, while maintenance is cheaper because wear parts for the heating-cooling mixer are no longer bought. The combination of lower capital expenditure and lower operating costs is presented as the basis for a fast payback.

Formulation adjustments and color changes can be implemented during operation through the integrated control system, the company says, without time-consuming preparation and intermediate storage of separate dryblend batches. Christopher Bartel, Head of Sales Flat & Foam at KraussMaffei Extrusion, framed this as a competitive advantage for membrane manufacturers: lower production costs, greater flexibility and more efficient manufacturing, with the ability to respond faster to new requirements and adjust formulations directly during production while reducing energy and capital expenditure.

Extruder configuration and validation trials

The process was developed at the KraussMaffei Extrusion Technology Center in Laatzen and validated using industrial roofing-membrane formulations. The trials used a co-rotating twin-screw extruder from the ZE 65 BluePower series, equipped with loss-in-weight feeders for all solid components and multiple liquid feeders for free-flowing formulation components. The series has a Da/Di ratio of 1.65; the company says the combination of high torque and large free volume provides a wide process window for processing different formulations flexibly.

Testing confirmed excellent gelation levels of the PVC and high product quality, with the mechanical properties and weldability of the membranes meeting industrial requirements across several formulations. Bartel said the results demonstrate the potential of PVC InlineMixing for industrial roofing membrane production, and that customers can test their own formulations under production-relevant conditions at the Technology Center, optimize the process and prepare for industrial implementation.

Industrial reference installation

The process is already in use in an industrial production line for PVC roofing membranes. That reference plant reaches a total throughput of 1,800 kg/h using two extruders and two calenders, continuously processing PVC, additives and fillers together with the resulting edge trimmings directly into finished membranes. KraussMaffei positions the approach as combining high product quality with a leaner production process.